Digital Acoustics EDB-110 Manuale Scaricare il pdf (Pagina 15)

- 15 -

ROUBLESHOOTING

TalkMaster requires correctly configured ii3-series intercoms installed on

the network to operate correctly. A overview of hardware troubleshooting

include:



Verify power connections. The "Active" LED on should be on or flashing.



Refer to LED Indicator section in your hardware manual for valuable

diagnostic information.



If you cannot detect ii3 units when you SCAN then be sure to verify that

the LINK LED is on and TalkMaster is running on the SAME network.



If you have multiple network cards on this PC verify that intercoms are

connected to the system that is using this computer's IP #. Verify that

your connection is on the SAME network that is running TalkMaster.



ii3 Intercoms may operate across some firewalls or specific VPNs. They

will need to be configured locally (for setup) and will need to be

assigned correct STATIC IP addresses for correct detection.



If using DHCP addressing try assignments using static IP addresses.



If you hear beeps try re-scanning a few seconds after the beep to

override DHCP addressing if you think that the intercoms are set for

DHCP and are running on a non DHCP network.



If you cannot detect any intercoms using the TalkMaster SCAN ALL

utility screen try directly connecting the PC (running TalkMaster) to the

ii3 intercom using a crossover cable (disconnected from the network).



Refer to your TalkMaster ii3-m or ED series manual for additional

diagnostic techniques and troubleshooting tools.

PC running

TalkMaster

ii3

intercom

Crossover Cable

1 2 ... 10 11 12 13 14 15 16 17

Nessun commento

Digital Acoustics EDB-110 Manuale Pagina 15